Configuration Guide
8
Accessing the Switch
Web Interface Access
Go to
System > Access Security > HTTPS Config
, disable the HTTPS server and click
Apply
.
Figure 2-6
Disbale the HTTPS Server
2.4 Configure the Switch's IP Address and Default Gateway
The default IP address of the switch is 192.168.0.1, and the default gateway is 0.0.0.0. You
can change the IP address and default gateway of the switch according to your needs.
Go to
System > System Info > System IP
to load the following page.
Figure 2-7
Change the default IP address
IP Address
Mode
Choose the IP address mode as Static IP.
Management
VLAN
This is the only VLAN through which you can get access to the switch. By default, all
the ports are belonged to VLAN 1, and VLAN 1 is the Management VLAN, you can
connect to the switch through VLAN 1. However, if another VLAN is created and set to
be the Management VLAN, you may have to reconnect the management station to a
port that is a member of the Management VLAN.
IP Address
Enter a new IP address. Make sure the route between the management host and the
switch’s new IP address id available.
Subnet Mask
Enter a new subnet mask.
Default Gateway
Enter your desired default gateway.
Summary of Contents for T2500G-10MPS
Page 1: ...User Guide T2500G 10MPS 1910012405 REV1 0 1 April 2018...
Page 24: ...Using the CLI 767 Appendix Default Parameters 773...
Page 145: ...Part 5 Monitoring Traffic CHAPTERS 1 Traffic Monitor 2 Appendix Default Parameters...
Page 172: ...Part 7 Configuring DDM CHAPTERS 1 Overview 2 DDM Configuration 3 Appendix Default Parameters...
