Configuration Guide
48
Managing System
System Tools Configurations
Note:
•
The switch will obtain a new IP address from the DHCP server during the process of Auto In-
stall. If you want to access to the switch, you should check the new IP address on the DHCP
server.
•
IF the Auto Install process is failed, the switch will restart the process every 10 minutes. You
can stop the process manually.
4.1.6 Rebooting the switch
Choose the menu
System
>
System Tools
>
System Reboot
to load the following page.
Figure 4-6
Rebooting the switch
In the S
ystem Reboot
section, select the desired unit and click
Reboot
.
Target Unit
Select the desired unit to reboot. By default, it is ALL Unit.
Save Config
Select this option to save the configuration before the reboot.
4.1.7 Configuring the Reboot Schedule
Choose the menu
System
>
System Tools
>
Reboot Schedule
to load the following page.
Figure 4-7
Configuring the Reboot Schedule
Follow these steps to restore the configuration of the switch:
1) In the
Reboot Schedule Setting
section, select one method and specify the
parameters.
Summary of Contents for T2500G-10MPS
Page 1: ...User Guide T2500G 10MPS 1910012405 REV1 0 1 April 2018...
Page 24: ...Using the CLI 767 Appendix Default Parameters 773...
Page 145: ...Part 5 Monitoring Traffic CHAPTERS 1 Traffic Monitor 2 Appendix Default Parameters...
Page 172: ...Part 7 Configuring DDM CHAPTERS 1 Overview 2 DDM Configuration 3 Appendix Default Parameters...
