Configuration Guide
254
Configuring GVRP
GVRP Configuration
LeaveAll Timer
(centisecond)
When a GARP participant is enabled, the LeaveAll timer is started. When the
LeaveAll timer expires, the GARP participant sends LeaveAll messages to request
other GARP participants to re-register all its attributes. After that, the participant
restarts the LeaveAll timer.
The timer ranges from 1000 to 30000 centiseconds. The default is 1000
centiseconds.
Join Timer
(centisecond)
Join timer controls the sending of Join messages. A participant starts the Join
timer after sending the first Join message. If the participant does not receive any
respond, it sends the second Join message when the Join timer expires. This
ensures that the Join message can be sent to other participants.
The timer ranges from 20 to 1000 centiseconds. The default is 20 centiseconds.
Leave Timer
(centisecond)
The Leave timer controls attribute deregistration. A participant sends a Leave
message if one of its attributes is deleted. The participant receiving the message
starts the Leave timer. If the participant does not receive any Join message
of the corresponding attribute before the Leave timer expires, the participant
deregisters the attribute.
The range is 60 to 3000 centiseconds. The default is 60 centiseconds.
LAG
Displays the LAG the port is in.
3) Click
Apply
.
Note:
•
The member port of an LAG follows the configuration of the LAG but not its own. The
configurations of the port can take effect only after it leaves the LAG.
•
When setting the timer values, make sure the values are within the required range. The
configuration value for LeaveAll should be greater than or equal to ten times the Leave value.
The value for Leave should be greater than or equal to two times the Join value.
2.2 Using the CLI
GVRP requires VLAN creation first. And you need to set the link type of the ports as Trunk,
for GVRP can be enabled only on trunk interfaces. For details, refer to
.
Step 1
configure
Enter global configuration mode.
Step 2
gvrp
Enable GVRP globally.
Step 3
interface { fastEthernet
port
| range fastEthernet
port-list
| gigabitEthernet
port
| range
gigabitEthernet
port-list
| port-channel
port-channel-id
| range port-channel
port-
channelid-list
}
Enter interface configuration mode.
Summary of Contents for T2500G-10MPS
Page 1: ...User Guide T2500G 10MPS 1910012405 REV1 0 1 April 2018...
Page 24: ...Using the CLI 767 Appendix Default Parameters 773...
Page 145: ...Part 5 Monitoring Traffic CHAPTERS 1 Traffic Monitor 2 Appendix Default Parameters...
Page 172: ...Part 7 Configuring DDM CHAPTERS 1 Overview 2 DDM Configuration 3 Appendix Default Parameters...
