Configuration Guide
536
Configuring ACL
ACL Configuration
1) Select a Standard-IP ACL ID from the drop-down list, enter a Rule ID, then specify the operation for
the matched packets.
ACL ID
Select a
Standard-IP
ACL from the drop-down list.
Rule ID
Enter an ID number to identify the rule.
It should not be the same as any existing
Standard-IP
ACL Rule IDs.
Operation
Select an action to be taken when a packet matches the rule.
Permit
: To forward the matched packets.
Deny
: To discard the matched packets.
2) Define the rule’s packet-matching criteria.
S-IP/Mask
Specify the source IP address with a mask. A value of 1 in the mask indicates
that the corresponding bit in the address will be matched.
D-IP/Mask
Specify the destination IP address with a mask. A value of 1 in the mask
indicates that the corresponding bit in the address will be matched.
3) (Optional) Select a time-range from the drop-down list.
Time-Range
Select a time-range during which the rule will take effect. The default value is
No Limit, which means the rule is always in effect.
Configuring the Extend-IP ACL Rule
Choose the menu
ACL > ACL Config > Extend-IP ACL
to load the following page.
Figure 2-6
Creating the Extend-IP ACL Rule
Follow these steps to create the Extend-IP ACL:
Summary of Contents for T2500G-10MPS
Page 1: ...User Guide T2500G 10MPS 1910012405 REV1 0 1 April 2018...
Page 24: ...Using the CLI 767 Appendix Default Parameters 773...
Page 145: ...Part 5 Monitoring Traffic CHAPTERS 1 Traffic Monitor 2 Appendix Default Parameters...
Page 172: ...Part 7 Configuring DDM CHAPTERS 1 Overview 2 DDM Configuration 3 Appendix Default Parameters...
