Configuring GVRP
Configuration Example
Configuration Guide
257
3
Configuration Example
3.1 Network Requirements
Department A and Department B of a company are connected using switches. Offices of
one department are distributed on different floors. As shown in Figure 3-1, the network
topology is complicated. Configuration of the same VLAN on different switches is required
so that computers in the same department can communicate with each other.
Figure 3-1
Network Topology
Switch 1
Switch 2
Switch 3
Switch 4
Switch 5
Switch 6
......
Dept. A: VLAN 10
Dept. A: VLAN 10
Dept. B: VLAN 20
Dept. B: VLAN 20
Gi1/0/1
Gi1/0/1
Gi1/0/1
Gi1/0/1
Gi1/0/1
Gi1/0/1
Gi1/0/3
Gi1/0/3
Gi1/0/2
Gi1/0/2
3.2 Configuration Scheme
To reduce manual configuration and maintenance workload, GVRP can be enabled to
implement dynamic VLAN registration and update on the switches.
When configuring GVRP, please note the following:
Before enabling GVRP, set the link type for all ports in the link as Trunk.
The two departments are in separate VLANs. To make sure the switches only
dynamically create VLAN of their own department, you need to set the registration
mode for ports on Switch 1 to Switch 4 as Fixed to prevents dynamic registration and
deregistration of VLANs and allow the port to transmit only the static VLAN registration
information.
To configure dynamic VLAN creation on other switches, set the registration mode of
the corresponding ports as Normal to allow dynamic registration and de-registration of
VLANs.
The following sections provide configuration procedure in two ways: using the GUI and
using the CLI.
Summary of Contents for T2500G-10MPS
Page 1: ...User Guide T2500G 10MPS 1910012405 REV1 0 1 April 2018...
Page 24: ...Using the CLI 767 Appendix Default Parameters 773...
Page 145: ...Part 5 Monitoring Traffic CHAPTERS 1 Traffic Monitor 2 Appendix Default Parameters...
Page 172: ...Part 7 Configuring DDM CHAPTERS 1 Overview 2 DDM Configuration 3 Appendix Default Parameters...
