Configuring LAG
LAG Configuration
Configuration Guide
113
Step 5
end
Return to privileged EXEC mode.
Step 6
copy running-config startup-config
Save the settings in the configuration file.
The following example shows how to add ports1/0/5-8 to LAG 2 and set the mode as static
LAG:
Switch#configure
Switch(config)#interface range gigabitEthernet
1/0/5-8
Switch(config-if-range)#channel-group
2
mode
on
Switch(config-if-range)#show etherchannel
2
summary
Flags: D - down P - bundled in port-channel U - in use
I - stand-alone H - hot-standby(LACP only) s - suspended
R - layer3 S - layer2 f - failed to allocate aggregator
u - unsuitable for bundling w - waiting to be aggregated d - default port
Group Port-channel Protocol Ports
----- --------- ------- -------------------------------
2 Po2(S) - Gi1/0/5(D) Gi1/0/6(D) Gi1/0/7(D) Gi1/0/8(D)
Switch(config-if-range)#end
Switch#copy running-config startup-config
Configuring LACP
Follow these steps to configure LACP:
Step 1
configure
Enter global configuration mode.
Step 2
lacp system-priority
pri
Specify the system priority for the switch.
To keep active ports consistent at both ends, you can set the priority of one device to be
higher than that of the other device. The device with higher priority will determine its active
ports, and the other device can select its active ports according to the selection result of
the device with higher priority. If the two ends have the same system priority value, the end
with a smaller MAC address has the higher priority.
pri:
System priority. The valid values are from 0 to 65535, and the default value is 32768. A
smaller value means a higher device priority.
Summary of Contents for T2500G-10MPS
Page 1: ...User Guide T2500G 10MPS 1910012405 REV1 0 1 April 2018...
Page 24: ...Using the CLI 767 Appendix Default Parameters 773...
Page 145: ...Part 5 Monitoring Traffic CHAPTERS 1 Traffic Monitor 2 Appendix Default Parameters...
Page 172: ...Part 7 Configuring DDM CHAPTERS 1 Overview 2 DDM Configuration 3 Appendix Default Parameters...
