Toyota Camry 2004, Owner'S Manual

Page: 188 / 330

’04Camry_U (L/O 0307)
187
2004 CAMRY from Jul. ’03 Prod. (OM33616U)
The garage door opener (
R
Universal Transceiver) is manufactured
under license from HomeLink
R
and can
be programmed to operate garage
doors, gates, entry doors, door locks,
home lighting systems, and security
systems, etc.
(a) Programming the HomeLink
R
The HomeLink
R
in your vehicle has 3
buttons and you can store one program
for each button.
To ensure correct programming into the
HomeLink
R
, install a new battery in the
hand − held transmitter prior to program-
ming.
The battery side of the hand
− held trans-
mitter must be pointed away from the
HomeLink
R
during the programming pro-
cess.
For Canadian users, follow the procedure
in “Programming an entrance gate/Pro-
gramming all devices in the Canadian
market”.
1. Decide which of 3 HomeLink
R
buttons
you want to program.
2. Place your hand − held garage transmit-
ter 25 to 75 mm (1 to 3 in.) away from
the surface of the HomeLink
R
.
Keep the indicator light on the HomeLink
R
in view while programming.
3. Simultaneously press and hold the
hand − held garage transmitter button
along with the selected HomeLink
R
but-
ton.
4. When the indicator light on the
HomeLink
R
changes from a slow to a
rapid flash after 20 seconds, you can
release both buttons.
5. Test the operation of the HomeLink
R
by
pressing the newly programmed button.
If programming a garage door opener,
check to see if the garage door opens
and closes.
If the garage door does not operate, iden-
tify if your garage transmitter is of the
“Rolling Code” type. Press and hold the
programmed HomeLink
R
button. The ga-
rage door has the rolling code feature if
the indicator light (on the HomeLink
R
)
flashes rapidly and then remains lit after
2 seconds. If your garage transmitter is
the “Rolling Code” type, proceed to the
heading “Programming a rolling code sys-
tem”.
6. Repeat steps 2 through 5 for each re-
maining HomeLink
R
button to program
another device.
Garage door opener