700H6–01
B51853
Handle of the hammer
–
WINDSHIELD/WINDOWGLASS/MIRROR
POWER WINDOW CONTROL SYSTEM
70–1
2534
Author:
Date:
2002 CAMRY REPAIR MANUAL (RM881U)
POWER WINDOW CONTROL SYSTEM
ON–VEHICLE INSPECTION
1.
CHECK POWER WINDOW (MANUAL OPERATION FUNCTION)
(a)
Turn the ignition switch ON.
(b)
Check that the door glass will rise when operating the power window regulator master switch to the
UP side, and the door glass will go down when operating it to the DOWN side.
(c)
Check that the door glass will rise when operating the power window regulator switch of each door to
the UP side, and the door glass will go down when operating it to the DOWN side.
(d)
Check that the other door glasses than the driver’s will not operate when locking the window locking
switch.
2.
CHECK AUTOMATIC OPERATION FUNCTION
HINT:
For the w/o jam protection models are (a), (b), and (d) only.
(a)
Turn the ignition switch ON.
(b)
Check that the AUTO UP operates and the door glass is fully closed when each window switch of the
regulator master switch assy is turned UP by double shift.
(c)
Check that the AUTO DOWN operates and the door glass is fully opened when each window switch
of the regulator master switch assy is turned DOWN by double shift.
(d)
Check that the door glass stops when the applicable switch is turned UP during the AUTO DOWN op-
eration. (However, if the switch is kept in the UP side, it will transfer to the manual operation.)
(e)
Check that the door glass stops when the applicable switch is turned DOWN during the AUTO UP op-
eration. (However, if the switch is kept in the DOWN side, it will transfer to the manual operation.)
3.
CHECK JAM PROTECTION FUNCTION (DRIVER’S DOOR GLASS, W/JAM PROTECTION)
(a)
Check the basic function.
NOTICE:
Never check it with any part of your body such as hand caught between the glass and the ve-
hicle’s body. Also, pay thorough attention not to get caught in there during the operation.
In case of resetting the power window motor, check should be carried out after repeating the
UP and DOWN operation several times by the AUTO and MANUAL UP operation.
HINT:
Jam protection function only works during the UP operation.
(1)
Open the door glass fully.
(2)
Set the handle of the hammer near the fully–closed
position.
(3)
When fully closing the door glass with the AUTO UP
and MANUAL UP operation, check that it moves
down without the hammer handle getting caught
and will go down by about 200 mm (7.87 in.) and
stop there.
HINT:
The window goes down by about 50 mm. In case that the open-
ing value is below 200 mm, the window goes down by 200 mm
or keeps going down for 5 seconds, and stops then.
(4)
During the lowering operation, check that it will not move up even when the window regulator
master switch is operated to the UP side.
