F41554
F41556
–
BRAKE
REAR DISC BRAKE
32–35
2023
Author:
Date:
2002 CAMRY REPAIR MANUAL (RM881U)
21.
INSPECT DISC THICKNESS
(a)
Using a micrometer, measure the disc thickness.
Standard thickness: 12.0 mm (0.472 in.)
Minimum thickness: 10.5 mm (0.413 in.)
22.
REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG
23.
REMOVE REAR DISC
(a)
Put matchmarks on the disc and the axle hub.
(b)
Remove the disc.
24.
INSTALL REAR DISC
(a)
Aligning the matchmarks, install the rear disc.
HINT:
When replacing the disc with new one, select the installation position where the disc has the minimum runout.
25.
INSTALL PARKING BRAKE SHOE ADJUSTING HOLE PLUG
26.
INSPECT DISC RUNOUT
(a)
Temporarily fasten the disc with hub nuts.
Torque: 103 N
⋅
m (1,050 kgf
⋅
cm, 76 ft
⋅
lbf)
(b)
Using dial indicator, measure the disc runout 10 mm (0.39
in.) away from the outer edge of the disc.
Maximum disc runout: 0.15 mm (0.0059 in.)
(c)
If the disc’s runout is maximum value or greater, check the
bearing play in the axial direction and check the axle hub
runout. (See page
30–2
)If the bearing play and axle hub
runout are not abnormal, adjust the disc runout or grind
it on a ”On–car” brake lathe.
27.
ADJUST PARKING BRAKE SHOE CLEARANCE(See page
33–21
)
28.
TEMPORARY TIGHTEN REAR DISC BRAKE BLEEDER PLUG
(a)
Temporarily tighten the bleeder plug to the disc brake cylinder.
29.
INSTALL REAR DISC BRAKE BLEEDER PLUG CAP
30.
INSTALL PISTON SEAL
(a)
Apply the lithium soap base glycol grease on a new piston seal.
(b)
Install the piston seal to the disc brake cylinder.
31.
INSTALL REAR DISC BRAKE DISC BRAKE PISTON
(a)
Apply the lithium soap base glycol grease on the piston.
(b)
Install the piston to the disc brake cylinder.