A01185
Piston Bushing
Inside Diameter
Mark
Connecting Rod
Bushing Inside Diameter Mark
Front Mark
Front Mark
A62247
Z00064
–
ENGINE MECHANICAL
CYLINDER BLOCK (2AZ–FE)
14–125
1649
Author:
Date:
2002 CAMRY REPAIR MANUAL (RM881U)
(c)
Using a caliper gauge, measure the inside diameter of the
connecting rod bushing.
Bushing inside diameter:
22.005 – 22.014 mm (0.8663 – 0.8667 in.)
HINT:
Bushing inside diameter
Mark
mm (in.)
A
22.005 – 22.008 (0.8663 – 0.8665)
B
22.008 – 22.011 (0.8665 – 0.8666)
C
22.011 – 22.014 (0.8666 – 0.8667)
(d)
Subtract the piston pin diameter measurement from the
piton pin hole diameter measurement.
Standard oil clearance:
0.001 – 0.007 mm (0.00004 – 0.00028 in.)
Maximum oil clearance: 0.010 mm (0.0020 in.)
(e)
If the oil clearance is greater than maximum, replace the
connecting rod. If necessary, replace the piston and pis-
ton pin as a set.
(f)
Subtract the piston pin diameter measurement form the
bushing inside diameter measurement.
Standard oil clearance:
0.005 – 0.011 mm (0.0002 – 0.0004 in.)
Maximum oil clearance: 0.010 mm (0.0020 in.)
(g)
If the oil clearance is greater than maximum, replace the
connecting rod. If necessary, replace the connecting rod
and piston pin as a set.
21.
INSPECT CONNECTING ROD SUB–ASSY
(a)
Using a rod aligner and feeler gauge, check the connect-
ing rod alignment.
(1)
Check for out–of–alignment.
Maximum out–of–alignment:
0.05 mm (0.0020 in.) per 100 mm (3.94 in.)
(b)
If out–of alignment is greater than maximum, replace the
connecting rod assembly.
