60081–01
H41697
–
SUPPLEMENTAL RESTRAINT SYSTEM
SEAT POSITION AIR BAG SENSOR
60–67
2450
Author:
Date:
2002 CAMRY REPAIR MANUAL (RM881U)
REPLACEMENT
HINT:
COMPNENTS: See page
60–66
1.
PRECAUTION(See page
60–1
)
2.
DISCONNECT BATTERY NEGATIVE TERMINAL(See page
60–1
)
3.
REMOVE FRONT SEAT TRACK COVER RH REAR INNER(POWER SEAT)
4.
REMOVE FRONT SEAT TRACK COVER LH REAR INNER(POWER SEAT)
5.
REMOVE SEAT TRACK COVER UPPER REAR(MANUAL SEAT)
6.
REMOVE SEAT TRACK UPPER RAIL COVER RH(MANUAL SEAT)
7.
REMOVE FRONT SEAT ASSY LH(See page
72–7
)
8.
REMOVE SEAT POSITION AIR BAG SENSOR
(a)
Disconnect the connector of the seat position sensor.
(b)
Using a torx socket wrench (T30), remove the torx screw
and seat position sensor.
9.
INSTALL SEAT POSITION AIR BAG SENSOR
(a)
Using a torx socket wrench (T30), install the seat position sensor with the torx screw.
Torque: 8.0 N
⋅
m (82 kgf
⋅
cm, 71 in.
⋅
lbf)
(b)
Connect the connector of the seat position sensor.
NOTICE:
Installation of the connector is done with the sensor assembly installed. Make sure the sensor
assembly is installed with the specified torque.
If the sensor assembly has been dropped, or there are cracks, dents or other defects in the
case, bracket or connector, replace the sensor assembly with a new one.
When installing the sensor assembly, take care that the SRS wiring does not interfere with other
parts and is not pinched between other parts.
After installation, shake the sensor assembly to check that there is no looseness.
10.
INSTALL FRONT SEAT ASSY LH
Torque: 36.8 N
⋅
m (375 kgf
⋅
cm, 27 ft
⋅
lbf)
11.
SRS WARNING LIGHT(See page
05–690
)