B57652
B56613
75–18
–
ENGINE HOOD/DOOR
REAR DOOR
2698
Author:
Date:
2002 CAMRY REPAIR MANUAL 185W (RM881U)
17.
REMOVE REAR DOOR OUTSIDE HANDLE ASSY LH
(a)
Pull and hold the release plate of the outside handle
frame, as shown in the illustration.
(b)
Pushing the outside handle in the arrow mark direction in
the illustration, remove the rear door outside handle.
NOTICE:
If the release plate is not pulled and held when removing
the outside handle assembly, then the release pate will in-
terfere with the outside handle and it will damage the re-
lease plate.
18.
REMOVE REAR DOOR OUTSIDE HANDLE FRAME SUB–ASSY LH
(a)
Using a torx wrench (T30), loosen the screw and remove the rear door outside handle frame.
19.
INSTALL REAR DOOR OUTSIDE HANDLE FRAME SUB–ASSY LH
(a)
Using a torx wrench (T30), install the rear door outside handle frame with the screw.
20.
INSTALL REAR DOOR OUTSIDE HANDLE COVER RH
(a)
Using a torx wrench (T30), install the rear door outside handle cover with the screw.
21.
INSTALL REAR DOOR W/MOTOR LOCK ASSY LH
(a)
Install a new door lock wire harness packing.
NOTICE:
If reusing the removed lock with rear door motor, the packing in the connecting part should be
replaced with a new one.
Be careful that grease and dirt will not stick to the packing surface in the connecting part.
Reusing the removed packing or using a damaged packing will cause water to penetrate
through the connecting part, and it will result in a malfunction of the door lock.
(b)
Engage the lock assembly with rear door motor with the release plate of the outside handle, and then
set it to the door panel.
NOTICE:
Make sure that the release plate of the outside handle frame is securely engaged with the lock assem-
bly.
(c)
Using a torx wrench (T30), install the rear door lock assembly with the 3 screws and bolt.
22.
INSTALL POWER WINDOW REGULATOR MOTOR ASSY LH
(a)
Using a torx wrench (T25), install the power window regulator motor with the 3 screws.
23.
INSTALL REAR DOOR WINDOW REGULATOR SUB–ASSY LH
(a)
Install the temporarily installed bolt securely.
(b)
Install the temporarily installed bolt to the window regulator to the rear door panel, and install the rear
door window regulator temporarily.
(c)
Tighten the 3 bolts and the temporarily installed bolt.
(d)
Disconnect the connector.