9901A–01
–
MAINTENANCE
CHASSIS
99–7
2744
Author:
Date:
2002 CAMRY REPAIR MANUAL (RM881U)
CHASSIS
ON–VEHICLE INSPECTION
1.
INSPECT STEERING LINKAGE
(a)
Check the steering wheel freeplay. (See page
50–3
)
(b)
Check the steering linkage for looseness or damage.
(1)
Check that the tie rod ends do not have excessive play.
(2)
Check that the dust seals and boots are not damaged.
(3)
Check that the boot clamps are not loose.
2.
INSPECT STEERING GEAR HOUSING OIL
(a)
Check the steering gear housing for oil leakage.
If leakage is found, check and repair the cause.
3.
INSPECT BALL JOINTS AND DUST COVERS
(a)
Inspect the ball joints for excessive looseness.
(1)
Jack up the front of the vehicle and place wooden blocks with a height of 180 – 200 mm (7.09
– 7.87 in.) under the front tires.
(2)
Lower the jack until there becomes about half a load on the front coil spring. Place stands under
the vehicle for safety.
(3)
Check that the front wheels are pointing straight ahead, and block them with chocks.
(4)
Using a lever, pry up the end of the lower arm, and check the amount of play.
Maximum ball joint vertical play: 0 mm (0 in.)
If there is any play, replace the ball joint.
(b)
Check the dust cover for damage.
4.
INSPECT DRIVE SHAFT BOOTS
(a)
Check the drive shaft boots for clamp looseness, oil leakage or damage.
5.
CHECK TRANSAXLE OIL (FLUID)
(a)
Visually check the transaxle for oil (fluid) leakage.
If leakage is found, check and repair the cause.
6.
ROTATE TIRES (See page
28–1
)