B56898
A
A
a
b
b
a
c
A – A
70–16
–
WINDSHIELD/WINDOWGLASS/MIRROR
BACK WINDOW GLASS
2549
Author:
Date:
2002 CAMRY REPAIR MANUAL (RM881U)
(f)
Apply adhesive.
(1)
Cut off the tip of the cartridge nozzle as shown in the
illustration.
Part No. 08850–00801 or equivalent
HINT:
After cutting off the tip, use all adhesive within the time de-
scribed in the table below.
Temperature
Tackfree time
35
C (95
F)
15 minutes
20
C (68
F)
100 minutes
5
C (41
F)
8 hours
(2)
Load the sealer gun with the cartridge.
(3)
Coat the glass with adhesive, as shown in the il-
lustration.
a: 8 mm (0.31 in.)
b: 12 mm (0.47 in.)
c: 6.5 mm (0.256 in.)
(g)
Install the glass.
(1)
Using a suction rubber, position the glass so that the reference marks are alined, and press it
in gently along the rim.
NOTICE:
Dry the primer coating for 3 minutes or more.
Check that the stoppers are attached to the body correctly.
Check the clearance between the body and glass.
(2)
Lightly press the glass front surface for close contact.
(3)
Using a scraper, remove any excess or protruding adhesive.
HINT:
Apply adhesive on the glass rim.
18.
INSTALL BACK WINDOW MOULDING OUTSIDE
(a)
Install a new windshield moulding to the windshield glass before the adhesive has hardened.
(b)
Hold the
windshield glass in place securely with protective tape or equivalent until the adhesive has
completely hardened.
(c)
Using a scraper, remove any excess or protruding adhesive before the adhesive has hardened.
NOTICE:
Take care not to drive the vehicle during the time described in the table below.
Temperature
Tackfree time
35
C (95
F)
1.5 hours
20
C (68
F)
5 hours
5
C (41
F)
24 hours
19.
WATER–LEAK CHECK AND REPAIREMENT
(a)
Conduct a leak test after the adhesive has completely hardened.
(b)
Seal any leak with sealant.
