Total Control MP/16, Operator'S Manual

Page: 13 / 182

Summary 2-1
Chapter 2 Installation
Summary
1 Check to make sure you have all the required accessories
(page 2-2).
2 Familiarize yourself with the location of the connectors and
DIP switches on the unit’s back panel and the function of the
LEDs on the front panel (pages 2-3 –2-4).
3
Place the unit on a desktop or in a rack (page 2-4).
4 Plug the unit into a power source (page 2-6).
5 Assign IP addresses to the MP/16 (pages 2-7–2-10).
6 Setup the MP/16 for either LAN (pages 2-11–2-12) or dial-up
SLIP management (pages 2-13–2-17)
7 Connect the modems to your Data Terminal Equipement (DTE)
and analog phone source (page 2-18) and set the modem DIP
Switches (pages 2-19–2-20).
8 Set up your Management Station. Be sure to compile the MIBs
on the disk that came with the MP/16 into your SNMP
management software. See your SNMP management software
guide. If you are using
Total Control Manager/SMP
(TCM) to
manage the MP/16, you will not need this disk, as these MIBs
are included with the software. See the TCM
Installation/Configuration Roadmap for instructions on
compiling the MIBs.