Total Control MP/16, Operator'S Manual

Page: 28 / 182

2-16 Installation
3 Connect the modem to the MP/16 Console port.
Use the RJ45-
to-DB-25/DB-9 serial cable to connect the modem to the
MP/16 Console port as pictured below:
To external modem
Dial into modem from
configuration console
Figure 2-9.
WAN connection using an external modem
Using an MP/16 Modem for Dial-up
Management
Use the same steps for setup as you would if you were using a
separate modem, with the following guidelines:
♦
In Step 2, Configuring the modem , don’t use the modem DIP
switches to configure the MP/16 modem if these settings are
going to conflict with those required to connect the other seven
modems to your DTE. Instead, use the equivalent AT
commands. AT commands that share functionality with DIP
switches can NOT be saved to the
modem’s
NVRAM.
However, once a management session is established, you can
use the
Auto Configuration feature to save these setting in the
MP/16’s management NVRAM.