Total Control MP/16, Operator'S Manual

Page: 86 / 182

4-8 Cellular
WARNING: Do NOT load cellular templates if you have made
special configuration changes to the modem. When you load a
template, it overwrites all settings with the modem defaults.
Instead, use the AT command string equivalent or configure
cellular parameters individually with the settings listed under the
appropriate template.
NOTE:
Only one template may be loaded at a time. If you wish
to activate both ETC and MNP10:
1. Load the ETC Cellular Template.
2. Configure the modem with the settings or AT Command
String listed for the MNP10 template.
MNP10 Cellular Template
TCM Command:
Load MNP10 Cellular Defaults
MIB Object : loadMnp10CllulrDflt(25)
AT Command
: &F4
AT Command String Equivalent: ATS60=3
This template includes the following settings:
♦
MNP10 Negotiation
AT Command: S60.0=1
♦
Enable MNP Extended Services
AT Command:
S60.1=1
ETC Mobile Cellular Template
TCM Command:
Load V42 Cellular Mobile Defaults
MIB Object : loadV42CllulrMblDflt(26)
AT Command
: &F5
AT Command String Equivalent: ATS66=103 S7=90 S10=100
Enables ETC when the modem is answering or dialing from a
cellular phone. Although the MP/16 is usually not located on the
mobile end (cell side) of a connection, you can advise callers to use
these settings when placing calls from mobile locations.
Settings for this template are identical to those for the ETC fixed
site template (&F6), except for the following setting:
♦
Enable ETC Mobile
AT Command:
S66.1=1