Total Control MP/16, Operator'S Manual

Page: 95 / 182

Result Codes 4-17
Result Code Enable
DIP Switch 3, DIP Switch 7
DIP Switch Override Command: Q n
Enable the modem’s result code messages. With Originate Only,
the modem only displays result codes when placing a call.
NOTE:
If there seems to be software incompatibility with some of
the result codes, try setting Register 27 to 128.
Settings: DIP Switch 3 ON/Q0 Results Enabled
DIP Switch 3 OFF/Q1 Results Disabled
DIP Switch 7 ON/Q2 Originate Only
Default: DIP Switch 3 OFF (Disabled)
DIP Switch 7 OFF (Result Codes in Originate and
Answer)
High Speed Result Codes
Command: S27.7=1
Determines if, on establishment of a connection, result codes above
9600 are sent to the DTE. The higher codes should be disabled if
there is a communications software incompatibility, and 9600 will
be displayed in place of the higher codes.
Default: S27.7=0 (Displays result codes set by X
n
)
250ms Delay Before Result Code
Command:
S13.2=1
Disables the 250-millisecond pause preceding transmission of
modem result codes.
Default: S13.2=0 (Enabled)