Total Control MP/16, Operator'S Manual

Page: 181 / 182

Index
Link Rate (AT Command) .....................D-12
Link Security.................................... 4-2–4-5
Load Number.......................................... F-5
Local Echo, Command Mode
DIP Switch 4.................................... 2-20
Local Gateway IP Address..................... B-5
Local SNMP Community Strings
...2-11, B-7
M
Main Menu.............................................. B-1
Management
dial-up (WAN).................................. 2-16
over a LAN.............................. 2-11–2-12
Management Station
defined............................................... 1-1
MIB
defined............................................... 1-2
MIB II Groups......................................... 3-4
MIBs
compiling in SNMP software .............. 2-1
using to manage the MP/16 See Chapter 4
MNP10................................................... 4-6
Modem Load Number............................. F-5
Modem Testing...................
See Appendix E
Modems
setup....................................... 2-18–2-23
Mounting in a Rack................................. 2-5
N
NAC
defined............................................... 3-2
NAC identifiers..................................... 3-10
NMC
defined............................................... 3-2
MIB commands................................ 3-19
NVRAM
AT Command...................................D-14
DIP switch setting to load from........ 2-20
DTE lockout.....................................D-14
saveToNvram MIB command
........... 3-20
saving IP addresses to ....................... B-8
storing phone numbers in................D-15
O
OID (object ID) definitions.................... 3-10
Online command mode
...........................C-4
P
Packet Size
reducing.......................................... D-23
Phone jacks.......................................... 2-18
Phone Numbers, storing...................... D-15
Pinouts, EIA RS-232 ports
.............. A-1–A-4
R
Rackmount Installations .......................... 2-5
Radio and Television Interference ...........F-3
Rate, link (AT Command).................... D-12
Received Data (RX)
Pin assignment...................................A-2
Regulatory Information ............................F-1
Remote Access...................................... C-5
Remote Configuration
IP addresses.................................... 2-10
Remote Digital Loopback ......................E-10
Repair.....................................................F-2
Request to Send (RTS)
Pin assignment...................................A-2
Reset Authorized Access List .................B-7
Reset, software
AT Command.................................... D-8
MIB command.................................. 3-21
Result Codes...............................4-16–4-21
DIP Switch 2 (verbal/numeric) .......... 2-20
DIP Switch 3 (display/suppress) ...... 2-20
DIP Switch 7 (disable in answer mode) 2-20
RI See Ring Indicate
Ring Indicate (RI)
Pin assignment...................................A-2
Ringer Equivalence .................................F-3
Rings
counting........................................... D-18
number before answering
................ D-18
RJ11 jacks............................................ 2-18
Routing........................................... B-5–B-6
RS-232 Pinouts.............................. A-1–A-4
RTS ...........................
See Request to Send
RTS/CTS Flow Control (AT Command) D-13
RX.................................. See Received Data
S
Saving to NVRAM
AT command................................... D-14
SNMP MIB command...................... 3-20