Total Control MP/16, Operator'S Manual

Page: 20 / 182

2-8 Installation
Follow these steps:
1
Make certain that the unit is powered off.
2 Set Console DIP switches.
The Console DIP switches are
located to the immediate left of the Console port. (See figure
2-5 below).
Console
DIP Switches
Figure 2-5. Location of Console DIP Switches
♦
DIP switch 3 must be is in the UP (OFF) position.
♦
Use DIP switches 1 and 2 to set the Console port speed to
the highest rate supported by your PC and communication
software (if unsure, leave at 9600 or set it to 19.2K).
The following table reflects the table labeled SPEED
printed on the back of the MP/16.
Table 2-2. Console Port Speed
Switch 1 Switch 2 Speed
OFF OFF 9600
OFF ON 19.2K
ON OFF 38.4K
ON ON 57.6K