Total Control MP/16, Operator'S Manual

Page: 124 / 182

C-10 Using AT Commands
Configuration Control
Use the %C n command to defer, restore, or execute remote access
configuration changes.
%C n Configuration control. Default = %C0
%C0 Defer configuration. Configuration changes ar e
deferred until the call is ended; they take effect for
ensuing connections.
%C1 Restore configuration. Use this command to cancel
any configuration changes made during remote
access and restore the original configuration.
However, commands that have been written to
NVRAM (with &W) will not be restored to their
previous settings. Additionally, if you have forced
immediate config uration changes (with %C2),
those changes cannot be reversed with %C1.
%C2 Execute configuration. Use this command to force
configuration changes to take effect immediately,
during the current connection. We recommend
against forcing immediate configuration changes
unless absolutely necessary, as this can result in an
unreliable connection or even a loss of connection.