Thermo Scientific thermoscientific Vanquish Pumps C, Operating Manual

Page: 43 / 296

4 • Unpacking
Pumps C, Pumps F ( VC-Pxx, VF-Pxx)
Operating Manual Page 43
Figure 3: Carrying handles on the device
No. Component
1 Carrying handles
2 Attachment screw (one on each carrying handle)
4. Place the device on a stable surface.
5. If applicable:
Remove any additional packing material. Leave any protective films
attached to the surfaces of the device until it is properly positioned
in the system stack.
6. Transport the device by the carrying handles to the installation site,
if it is not already there, and place it in the system stack (see System
Arrangement (
}
page 52) ).
7. On each carrying handle, loosen the attachment screw until the
carrying handle is moveable in the rail. Do not remove the screws
from the carrying handles completely.
8. Slide off the carrying handles from the rails towards the rear of the
device.
Figure 4: Sliding off the carrying handle from the left rail
TIP Keep the shipping container, the carrying handles with the
attachment screws, and all packing material. These items will be needed
if the device is transported to a new location or shipped.
9. Some surfaces including the doors of the device are covered by a
protective film during shipment. Remove the protective film from all
surfaces as applicable.