74
Address
Range
Remark
System
address
1 to 30
Address 1 is used for the master unit.
Other addresses are for the slave units. The slave
units connected with a single master unit must have
different system addresses.
Personal
computer
address
1 to 30
The
Personal computer
address may be set only
when the system address is 1. It is the GP-IB
address for the GP-IB interface. It is a number for
equipment specification for the USB interface.
RS-232C uses no
Personal computer
address.
Turn on the unit while holding the
A
key to set the system address
and/or Personal computer address. The model name and version
data are displayed first, and the interface type is displayed. Then, the
system address may be set *
1
.
“Sy.Ad” is displayed on the voltage
7-segment LED, and the address is displayed on the current 7-segment
LED. Rotate the encoder to select the proper address, and press the
ENTER
/
CHECK
key.
The selected system address is validated. A unit whose system
address is other than 1 provides normal operation.
*1: Keep the
A
key depressed until
“Sy.Ad” is displayed.
System address 1
Personal computer
address 4
When the system address 1 is set,
“PC.Ad” is displayed on the voltage
7-segment LED, indicating that a Personal computer address may be
set. Rotate the encoder to select the proper address, and press the
ENTER
/
CHECK
key. The Personal computer address is validated, and the
unit provides normal operation.
The unit stores the system address and Personal computer address,
which will remain valid even after power of the unit is turned off until
they are changed.
