65
6-4-2. Master-slave connection using optional kits
The optional kits facilitate master-slave connection of two units and
offer sufficient rigidity.
How to Connect Units Vertically
(1) Remove the rubber shoes from the bottom of unit A. (Keep the
removed rubber shoes and screws with care not to lose them.)
(2) Fix the joint kit (JK-10) to the top panel of the unit B with the flat
countersunk head screws supplied with the kit.
(Four positions)
(3) Place the units as shown in Fig. 6-6 below so that the projections of the
JK-10 on the unit B are inserted in the holes in the unit A, from which
the rubber shoes are removed above.
(4) Shift the unit A, and fix the rear panel to the brackets of the joint kit
(JK-10) firmly with the screw with washer supplied with the kit.
(Two positions)
Unit A
Unit B
(Viewd from side
）
Unit A
Unit B
（
Shift and screw
）
Connection for Vertical Installation
Fix JK-10 with attached
screw at 4 positions
2 positions
Fig.6-6 Connection for Vertical Installation
