81
8-8-4. OCP setting (
：
CURR
：
PROT)
This command sets or inquires about the OCP (over-current protection)
value.
Setting
：
CURR
：
PROT<value>
Sets the OCP value of a one-output model.
：
CURR
：
PROT
：
A<value>
Sets the OCP value of CHA.
：
CURR
：
PROT
：
B<value>
Sets the OCP value of CHB.
The <value> range in single-unit operation is as shown below:
PSF-400L & PSF-400L2: 1.00 to 42.00
PSF-800L: 1.00 to 84.00
Two decimal places are valid.
The setting range changes in power extension master-slave
(parallel) operation.
Resolution in parallel operation: 100mA
Setting range: 0.0 to (total current x 1.05)
Application
example
：
CURR:PROT 10.10
Sets the OCP value of a one-output model to 10.10A.
Query
：
CURR
：
PROT?
Inquires about the set OCP value of a one-output model.
：
CURR
：
PROT
：
A?
Inquires about the set OCP value of CHA.
：
CURR
：
PROT
：
B?
Inquires about the set OCP value of CHB.
Response
example
10.10
Indicates that the set OCP value is 10.10A.
Remark
In tracking operation, setting of the CHA reflects upon the CHB
and CHB setting causes an execution error.
