20
>
Use the
left/right arrow keys
to set the CI-slot in which the CI-module for dual
decoding will be installed. Select
CI1
,
CI2
or
CI1+CI2
. Select
auto
, if you prefer
automatic identification. CI dual decoding is switched off in the
off
setting.
Refer to Section 7.3.3 as well.
6.4.4 Network settings
You have the possibility to optimise the digital receiver to match your Ethernet network in this
sub-menu.
Accept settings
In order to save the settings made in this menu, please proceed as follows:
>
Press the
green Accept
control key to save the alteration sand to return to the
Settings
menu.
alternatively:
>
Press the
red
Return
control key
.
A query is displayed according to.
>
Mark the YES field using the
left/right arrow keys
, if you want to save the chan-
ges and then press
OK
to confirm.
This will return you to the previous menu.
or
>
Press the
TV/Radio
key to return to standard operation.
The settings will
not
be saved.
7 Operation
7.1 Turning on and off
>
Turn the digital receiver on by pressing the
On/Standby
key on the device or on the
remote control.
>
Press the key once again to switch the unit off again.
>
The unit is now ready for operation (stand-by) and the clock will be displayed (provi-
ded that it was activated in Section 6.2.4) on the unit.
The device must read in the time, if it is not displayed. You can do this by switching
the device on and receiving a channel, e.g. ZDF, for approx. 30 seconds so that the
time can be read in automatically.
7.2 program selection
7.2.1 By means of the program up/down keys
>
Use the
up/down program keys
on the receiver or remote control to move up or
down to a new program position.
49773_DigiCorder_K2_EN.qxd 1.11.2007 14:57 Str. 20
