Suzuki VLR1800, Service Manual

Page: 427 / 624

Rear Suspension: 2C-6
8) Loosen the swingarm pivot shaft clamp bolt (3) and
remove the swingarm pivot shaft (4) with the special
tool.
Special tool
(A): 09944–28320 (Hexagon socket (19
mm))
9) Remove the cushion rods (5).
10) Remove the cushion lever (6).
Installation
Install the swingarm in the reverse order of removal. Pay
attention to the following points:
• Temporarily tighten the cushion lever upper nut (1)
and cushion lever lower nut (2).
• Install the washer and swingarm pivot shaft.
• Tighten the swingarm pivot shaft (3) to the specified
torque with the special tool.
Special tool
(A): 09944–28320 (Hexagon socket (19 mm))
Tightening torque
Swingarm pivot shaft (a): 100 N·m (10.0 kgf-m,
72.5 lb-ft)
• Tighten the swingarm pivot shaft clamp bolt (4).
(A)
4
3
I822H1230024-01
5
I822H1230025-01
6
I822H1230026-01
1
2
I822H1230027-02
(a)
3
4
(A)
I822H1230030-03