Suzuki VLR1800, Service Manual

Page: 318 / 624

1E-6 Engine Lubrication System:
Oil Cooler Removal and Installation
B822H11506005
Removal
1) Drain engine oil and engine coolant. Refer to
“Engine Oil and Filter Replacement in Section 0B
(Page 0B-11)” and “Cooling System Inspection in
Section 0B (Page 0B-15)”.
2) Remove the Oil filter. Refer to “Engine Oil and Filter
Replacement in Section 0B (Page 0B-11)”.
3) Disconnect the oil cooler hoses (1).
4) Remove the washer (3) and oil cooler (4) by
removing the union bolt (2).
Installation
Install the oil cooler in the revers order of removal. Pay
attention to the following points:
• Apply grease to the O-ring.
CAUTION
!
Use a new O-ring to prevent oil leakage.
NOTE
When installing the oil cooler, fit the concave
part “A” of the oil cooler onto the convex part
“B” of the crankcase.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
• Tighten the union bolt to the specified torque.
Tightening torque
Oil cooler union bolt (a): 70 N·m (7.0 kgf-m, 50.5
lb-ft)
1
1
I822H1150016-01
2
4
3
I822H1150017-01
“A”
“B”
I822H1150021-02
(a)
I822H1150022-02