Suzuki VLR1800, Service Manual

Page: 199 / 624

Emission Control Devices: 1B-14
Installation
1) Install the EVAP system purge control solenoid valve
as shown in the EVAP canister hose routing
diagram. Refer to “EVAP Canister Hose Routing
Diagram (Only for E-33) (Page 1B-8)”.
2) Reinstall the removed parts.
Fuel Shut-off Valve
Removal
1) Remove the battery holder (1). Refer to “Battery /
Battery Holder Removal and Installation in Section
1J (Page 1J-11)”.
2) Disconnect the surge hoses (2).
3) Remove the fuel shut-off valve (3).
Installation
1) Install the fuel shut-off valve as shown in the EVAP
canister hose routing diagram. Refer to “EVAP
Canister Hose Routing Diagram (Only for E-33)
(Page 1B-8)”.
2) Reinstall the removed parts.
Evaporative Emission Control System
Inspection (For E-33 only)
B822H11206010
Refer to “Evaporative Emission Control System Removal
and Installation (Only for E-33) (Page 1B-13)”.
Hose
Inspect the hoses for wear or damage. If it is worn or
damage, replace the hose with a new one.
NOTE
Make sure that the hoses are securely
connected.
EVAP Canister
Inspect the EVAP canister body for damage to the body.
If any defect is found, replace the EVAP canister with a
new one.
EVAP System Purge Control Solenoid Valve
NOTE
EVAP system purge control solenoid valve
can be checked without removing it from the
motorcycle. Refer to “DTC “C62” (P0443):
EVAP System Purge Control Solenoid Valve
Circuit Malfunction (For E-33) in Section 1A
(Page 1A-110)”.
1) Check that no air flows through both of the air inlet
and outlet ports. If air flows out, replace the EVAP
system purge control solenoid valve with a new one.
1
I822H1120023-02
2
3
I822H1120024-01
I822H1120025-02
I822H1120026-01