1C-3 Engine Electrical Devices:
IAT Sensor Removal and Installation
B822H11306024
Removal
1) Remove the fuel tank. Refer to “Fuel Tank Removal
and Installation in Section 1G (Page 1G-8)”.
2) Disconnect the IAT sensor coupler (1) and remove
the IAT sensor (2).
Installation
Install the IAT sensor in the reverse order of removal.
ECT Sensor Removal and Installation
B822H11306008
Removal
1) Drain engine coolant. Refer to “Cooling System
Inspection in Section 0B (Page 0B-15)”.
2) Remove the throttle body. Refer to “Throttle Body
Removal and Installation in Section 1D (Page 1D-
10)”.
3) Remove the intake pipes (1).
4) Remove the thermostat case (2) along with the water
hose.
5) Remove the ECT sensor (3).
CAUTION
!
Take special care when handling the ECT
sensor. It may cause damage if it gets an
excessive impact.
Installation
Install the ECT sensor in the reverse order of removal.
Pay attention to the following points:
• Tighten the ECT sensor (1) to the specified torque.
CAUTION
!
Use the new gasket washer (2) to prevent
engine coolant leakage.
Tightening torque
ECT sensor (a): 18 N·m (1.8 kgf-m, 13.0 lb-ft)
1
2
I822H1130019-01
1
I822H1130005-01
2
I822H1130006-01
3
I822H1130007-01
(a)
1
2
I822H1130008-02
Summary of Contents for VLR1800
