Subaru B9 TRIBECA WX 2007, Manual

Page: 588 / 861

LAN(diag)-13
Subaru Select Monitor
LAN SYSTEM (DIAGNOSTICS)
2. READ CURRENT DATA
1) On the «Main Menu» display screen, select the {Each System Check}.
2) On the «System Selection Menu» display screen, select the {Integ. unit mode}.
3) On the «Integ. unit mode failure diag» display screen, select the {Current Data Display & Save}.
4) On the «Current Data Display & Save» display screen, select the {12 Data Display}.
5) Using the scroll key, scroll the display screen up or down until the desired data is shown.
• A support list contains both of analog and digital data, and they are shown in the following table.
3. DISPLAY OF ANALOG DATA
Items to be displayed Unit of measure Description Note
BATT Voltage (Control) 10 — 15 V Body integrated unit input value Always
BATT Voltage (BACK UP) 10 — 15 V Body integrated unit input value Always
IG Power Supply Voltage 10 — 15 V Body integrated unit input value Ignition switch ON
ACC voltage 10 — 15 V Body integrated unit input value Ignition switch ACC
Illumination VR voltage 0 — 5 V Body integrated unit output value Small light switch ON
Illumi. output d-ratio 0 — 100% Body integrated unit input value
Small light ON
Illumination volume is other than bright.
Ambient temp sensor V 0 — 5 V Body integrated unit input value Ignition switch ON
Ambient Temperature –40 — 87.5°C Body integrated unit output value Ignition switch ON
Fuel level voltage 0 — 8 V Body integrated unit input value Ignition switch ON
Fuel level resistance 0 — 102.3
Ω
Body integrated unit input value Ignition switch ON
key-lock solenoid V 6 — 12 V Body integrated unit output value
Key warning switch ON, in range other
than parking Ignition ON
number of regist. 0 — 4 No. of Keyless keys to register
Front Wheel Speed km/h CAN data input value Reception from VDC unit
VDC/ABS latest f-code
DTC display
(Temporarily)
CAN data input value
It is normal when DTC is not been input
even if this code is displayed.
Reception from VDC
Blower fan steps 0 — 2 levels CAN data input value
0: OFF, 1: Low, 2: 2 levels or more
Reception from air conditioner ECM
Fuel level resistance2 0 — 102.3
Ω
CAN data output value Reception from body integrated unit
Fuel consumption cc/s CAN data input value
Reception from ECM and transmission to
center monitor
Coolant Temp. –40 — 130°C CAN data input value Reception from ECM
Vehicle lateral G m/s
2
CAN data input value Reception from VDC unit
SPORT Shift Stages 0 — 7 levels CAN data input value
Manual mode operating information
(0: Light OFF; 1 — 5: Gear display; 6:
Fail; 7: ATF temperature High/Low)
Reception from TCM
Shift Position 0 — 7 levels CAN data input value
0: 1; 1: 2; 2: 3; 3: 4; 4: D; 5: N; 6: R; 7: P
shift position (8 indicates no input)
On manual mode, 8 is displayed.
Reception from TCM
Off delay time
OFF, Short,
Normal, Long
Body integrated unit setting items Customize setting
Auto lock time
20, 30, 40, 50, 60
seconds
Body integrated unit setting items Customize setting
asieps_tobira.book 13 ページ ２０１２年２月１０日 金曜日 午後３時２６分