Subaru B9 TRIBECA WX 2007, Manual

Page: 80 / 861

AB(diag)-5
General Description
AIRBAG SYSTEM (DIAGNOSTICS)
• If damage, open circuit or rust is found on airbag
system wiring harness, do not use a soldering
equipment to repair. Replace the faulty harness
with a new genuine part.
• Install the wiring harness securely with the spec-
ified clips to avoid interference or tangled with other
parts.
• Do not allow water or oil to come in contact with
the connector terminals. Also do not touch the con-
nector terminals.
• Do not disassemble driver’s airbag module, pas-
senger’s airbag module, side or curtain airbag
modules, or pretensioner.
• The airbag module cannot be used again if de-
ployed once.
• After removal, keep the airbag module with the
pad side facing upward on a dry, clean and flat sur-
face away from heat, light sources, moisture and
dust.
• Do not check continuity of the airbag modules for
driver’s side, passenger’s side and curtain, or the
pretensioner.
• The removed front seat with airbag module must
be kept at least 200 mm (8 in) away from walls and
other objects.
• When painting or performing sheet metal work
on the front part of the vehicle, including the front
wheel apron, front fender and front side frame, re-
move the front sub sensors and wiring harness of
airbag system.
NG G G G G G G G G G G G G G G G G G G G NG G N NG G N N N N N N N N N N G N N N N N NG G G G
AB-01539
AB-00125
AB-01540
G G NG G G G G G G G G G G G G G G G G G G G G G G G G G G G G G NG N N N N N N N N N N N NG N N N N N N N N N G N N N NG G G G G
AB-01541
NG NG NG G G N N N N N N N NG G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G G N G G G G G G G G G G G G G G G G G N N N N N N N N N N N NG G G G G G G G NG G G G NG NG NG
(1) 200 mm (8 in) or more
AB-00056
NG NG NG NG N N NG G NG NG NG NG NG N N N N N N N N N N N N N N N N N N NG G N N N NG NG G G G G G N N NG G G N NG G NG G G G G G G G G G G G G G G G G G G
AB-01537
AB-00128
(1)
asieps_tobira.book 5 ページ ２０１２年２月１０日 金曜日 午後３時２６分