Subaru B9 TRIBECA WX 2007, Manual

Page: 147 / 861

AB(diag)-72
Diagnostic Chart with Trouble Code
AIRBAG SYSTEM (DIAGNOSTICS)
Step Check Yes No
1 CHECK POOR CONTACT.
1) Turn the ignition switch to OFF, disconnect
the battery ground cable, and wait more than 20
seconds.
2) Confirm that the connector that is between
the airbag control module and the passenger’s
side warning box is securely connected.
Is there poor contact in any
connector? Replace the airbag
harness. Go to step 2 .
2 CHECK AIRBAG MAIN HARNESS.
1) Disconnect the connector (AB6) from airbag
control module.
2) Connect the battery ground terminal and
turn the ignition switch to ON.
NOTE:
Neither of ON/OFF illuminates when it is nor-
mal.
Is the passenger’s seat airbag
indicator lit? Go to step 3 . Go to step 4 .
3 CHECK AIRBAG MAIN HARNESS.
1) Turn the ignition switch to OFF.
2) Remove the passenger’s side warning box
and disconnect the connector (i116).
3) Connect the connector (1U) in the test har-
ness U to connector (AB6).
4) Measure the resistance between connec-
tors (2U) and (4U) in the test harness U and
chassis ground.
Connector & terminal
(2U) No. 14 — (4U) No. 17:
(2U) No. 14 — Chassis ground:
(4U) No. 17 — Chassis ground:
Is the resistance more than 1
M
Ω
?
Replace the pas-
senger’s side
warning box. <Ref.
to AC-49,
REMOVAL, Air
Vent Grille.> Repair the bulk-
head harness. Or
replace the airbag
main harness
along with bulk-
head harness.
4 CHECK THE AIRBAG HARNESS.
1) Connect the connector (1U) in the test har-
ness U to connector (AB6).
2) Connect the connectors (7U) and (8U) in the
test harness U.
3) Connect the battery ground terminal and
turn the ignition switch to ON.
Is the passenger’s seat airbag
indicator lit? Replace the airbag
control module.
<Ref. to AB-19,
Airbag Control
Module.> Go to step
5
.
5 CHECK THE AIRBAG HARNESS.
1) Turn the ignition switch to OFF.
2) Measure the resistance between connec-
tors (2U) and (4U) in the test harness U and the
connector (i116).
Connector & terminal
(2U) No. 14 — (i116) No. 5:
(4U) No. 17 — (i116) No. 6:
Is the resistance less than 10
Ω ?
Go to step
6
. Repair the bulk-
head harness. Or
replace the airbag
main harness
along with bulk-
head harness.
6 CHECK BODY HARNESS.
1) Turn the ignition switch to ON.
2) Measure the voltage between connector
(i116) and chassis ground.
Connector & terminal
(i116) No. 3 (+) — Chassis ground (–):
Is the voltage 10 V or more? Replace the pas-
senger’s side
warning box. <Ref.
to AC-49,
REMOVAL, Air
Vent Grille.> Repair the power
supply line to the
passenger’s side
warning box.
asieps_tobira.book 72 ページ ２０１２年２月１０日 金曜日 午後３時２６分