Subaru B9 TRIBECA WX 2007, Manual

Page: 680 / 861

LI-1 8
Front Fog Light Assembly
LIGHTING SYSTEM
15.Front Fog Light Assembly
A: REMOVAL
1) Disconnect the ground cable from the battery.
2) Disengage the three clips, and then turn over the
lower mud guard.
3) Disconnect the harness connector.
4) Remove the two mounting bolts, and pull and
detach the fog light assembly.
B: INSTALLATION
Install in the reverse order of removal.
C: ADJUSTMENT
Fog light aiming
NOTE:
Before checking the fog light beam level, be sure of
the following:
• Check the area around the fog light for any
scratches, damage or other type of deformation.
• Make sure that the vehicle is parked on a level
surface.
• Make sure that the inflation pressure of tires are
correct.
• Check that the vehicle fuel tank is full.
1) Bounce the vehicle several times to normalize
the suspension.
2) Make certain that someone is seated in the driv-
er’s seat.
3) Measure the height of the center of fog light.
4) Disengage the three clips, and then turn over the
mud guard.
5) Insert a Phillips driver into the adjustment hole
and adjust the front fog light pattern.
LI-00509
(1) Adjustment hole
LI-00686
(A)
(A) Center of vehicle (B) 3 m (10 ft) (H) Height of the center of fog light
(mm)
LI-00403
H
H
(A)
(A)
(B)
h
(h)
h Dimension mm (in) 40 (1.57)
asieps_tobira.book 18 ページ ２０１２年２月１０日 金曜日 午後３時２６分