Subaru B9 TRIBECA WX 2007, Manual

Page: 69 / 861

AB-1 8
Curtain Airbag Module
AIRBAG SYSTEM
7. Curtain Airbag Module
A: REMOVAL
CAUTION:
Refer to “CAUTION” of “General Description”
before handling the airbag module. <Ref. to AB-
4, CAUTION, General Description.>
1) Turn the ignition switch to OFF.
2) Disconnect the ground cable from battery and
wait for at least 20 seconds before starting work.
3) Remove the front pillar upper trim and center pil-
lar upper trim. <Ref. to EI-43, FRONT PILLAR UP-
PER TRIM, REMOVAL, Side Trim.> <Ref. to EI-44,
CENTER PILLAR UPPER TRIM, REMOVAL, Side
Trim.>
4) Remove the rear quarter trim. <Ref. to EI-45,
REMOVAL, Rear Quarter Trim.>
5) Remove the roof trim. <Ref. to EI-50, REMOV-
AL, Roof Trim.>
6) Disconnect the connector from curtain airbag
module.
7) Remove the bolts, and then remove the curtain
airbag module.
CAUTION:
• Be careful not to damage the curtain airbag
module during removal.
• Never open the curtain airbag module before
deploying it. Never reuse the deployed curtain
airbag module.
8) Remove the front piller from front pillar pad.
B: INSTALLATION
CAUTION:
• Refer to “CAUTION” of “General Description”
before handling the airbag module. <Ref. to AB-
4, CAUTION, General Description.>
• When installing the curtain airbag module, in-
stall a specified part at specified place.
• Be careful not to damage the curtain airbag
module during removal.
• Never open the curtain airbag module before
deploying it. Never reuse the deployed curtain
airbag module.
• Make sure that there are no foreign matter on
airbag module.
Install in the reverse order of removal.
Tightening torque:
7.5 N·m (0.77 kgf-m, 5.5 ft-lb)
C: INSPECTION
CAUTION:
Refer to “CAUTION” of “General Description”
before handling the airbag module. <Ref. to AB-
4, CAUTION, General Description.>
Check for the following, and replace the damaged
parts with new parts. <Ref. to AB-12, CURTAIN
AIRBAG MODULE, INSPECTION, Inspection Lo-
cations After a Collision.>
1) With side collision (when curtain airbag is de-
ployed)
• Curtain airbag module assembly
• Roof trim
• Front pillar upper trim
• Front piller pad (blue)
• Center pillar upper trim
• Center piller pad (green)
• Rear quarter upper trim
• Rear quarter piller pad (red)
• Airbag guide
2) When damage is found by visual check
• Assist grip
• Assist grip bracket
• Curtain airbag harness and connector on body
side
3) With side collision (when curtain airbag is not de-
ployed)
Check the roof trim, pillar trim and airbag module
visually, and then replace them with new parts if
damaged or cracked.
Specially inspect the damage of airbag module
body, mounting bracket and harness connector.
4) Without side collision (dirt and damage of cover)
Replace the corresponding part with a new part.
AB-01527
AB-01279
asieps_tobira.book 18 ページ ２０１２年２月１０日 金曜日 午後３時２６分