Subaru B9 TRIBECA WX 2007, Manual

Page: 645 / 861

LAN(diag)-70
Diagnostic Procedure with Diagnostic Trouble Code (DTC)
LAN SYSTEM (DIAGNOSTICS)
Step Check Yes No
1 CHECK DTC.
Connect the Subaru Select Monitor and read
the DTC of the body integrated unit.
Are there any other DTC
besides U1301? Perform diagnosis
according to other
DTC. Go to step 2 .
2 CHECK DTC.
Check the DTC displayed in the body integrated
unit.
Is the DTC displayed a current
malfunction? Replace the body
integrated unit.
<Ref. to SL-51,
REMOVAL, Body
Integrated Unit.> Go to step 3 .
3 CHECK DTC.
Turn the ignition switch to OFF, and read the
DTC again.
Is U1301 a current malfunc-
tion? <Ref. to
LAN(diag)-70,
DTC U1301 CAN-
LS COUNTER
ABNORMAL,
Diagnostic Proce-
dure with Diagnos-
tic Trouble Code
(DTC).> Temporary poor
contact occurs.
4 CHECK CURRENT DATA.
Check the current data (auto A/C failure) of the
body integrated unit using the Subaru Select
Monitor.
Is OK displayed? Go to step 5 . Perform the auto A/
C self-diagnosis.
<Ref. to AC(diag)-
10, OPERATION,
Diagnostic Chart
for Self-diagno-
sis.>
5 CHECK CURRENT DATA.
Check current data (center display failure) of the
body integrated unit.
Is OK displayed? Go to step 6 . Repair or replace
the center display
or MFD. <Ref. to
ET-22, REMOVAL,
Navigation Dis-
play.>
6 CHECK AUTO A/C CONTROL MODULE.
1) Display the current data of body integrated
unit using Subaru Select Monitor.
2) Display the number of blower fan speed in
the analog data.
3) Read the data display when the number of
blower fan speed is changed on air conditioner
control part.
Does the data display change? Go to step
7
. Go to step
8
.
7 CHECK COMBINATION METER.
1) Display the current data of body integrated
unit using Subaru Select Monitor.
2) Display the door switch in analog data.
3) Read the display of data and combination
meter when each door is opened/closed.
Do the body integrated unit
data indicator and combination
meter indicator change accord-
ing to operation? Go to step 8 . Go to step 9 .
8 CHECK AUTO A/C CONTROL MODULE
HARNESS.
1) Disconnect the auto A/C control module
connector.
2) Disconnect the body integrated unit connec-
tor.
3) Measure the resistance of harness between
body integrated unit and auto A/C control mod-
ule.
Connector & terminal
(B280) No. 26 — (D283) No. 1:
(B280) No. 25 — (D283) No. 14:
Is the resistance less than 10
Ω
?
Go to step 10 . Repair the open
circuit of harness
or replace har-
ness.
asieps_tobira.book 70 ページ ２０１２年２月１０日 金曜日 午後３時２６分