Subaru B9 TRIBECA WX 2007, Manual

Page: 587 / 861

LAN(diag)-12
Subaru Select Monitor
LAN SYSTEM (DIAGNOSTICS)
6. Subaru Select Monitor
A: OPERATION
1. READ DIAGNOSTIC TROUBLE CODE
(DTC)
NOTE:
• DTC is displayed in the sequence of inputting.
(When inputting two DTCs or more simultaneously,
they are displayed in the sequence of priority.)
• When more than two DTCs are displayed, per-
form the diagnosis of top one.
1) Prepare the Subaru Select Monitor kit.
2) Connect the diagnosis cable to Subaru Select
Monitor.
3) Connect the Subaru Select Monitor to data link
connector.
Data link connector is located in the lower portion of
instrument panel (on the driver’s side).
CAUTION:
Do not connect the scan tools except for Suba-
ru Select Monitor.
4) Turn the ignition switch to ON (engine OFF) and
run the Subaru Select Monitor.
5) On the «Main Menu» display screen, select the
{Each System Check}.
6) On the «System Selection Menu» display
screen, select the {Integ. unit mode}.
7) On the «Integ. unit mode failure diag» display
screen, select the {Diagnostic Code(s) Display}.
NOTE:
It is possible to read the DTC at the {Check all di-
agnosis codes} on the «Main Menu», and then find
the contents to check from the DTC table. <Ref. to
LAN(diag)-30, DTC TABLE, LIST, List of Diagnos-
tic Trouble Code (DTC).>
NOTE:
• For details concerning operation procedure, re-
fer to the “SUBARU SELECT MONITOR OPERA-
TION MANUAL”.
• For details concerning DTCs, refer to the List of
Diagnostic Trouble Code (DTC). <Ref. to LAN(di-
ag)-28, List of Diagnostic Trouble Code (DTC).>
LAN00189
asieps_tobira.book 12 ページ ２０１２年２月１０日 金曜日 午後３時２６分