Subaru B9 TRIBECA WX 2007, Manual

Page: 108 / 861

AB(diag)-33
Subaru Select Monitor
AIRBAG SYSTEM (DIAGNOSTICS)
2. DISPLAY OF STATUS INFORMATION
Check the operating condition of each sensor in the event of malfunction in seat belt buckle switch and seat
position sensor, or when the seat belt buckle switch and seat position sensor has been replaced.
1) On the «Main Menu» display screen, select the {Each System Check}.
2) On the «System Selection Menu» display screen, select the {Airbag System}.
3) On the «Airbag System» display screen, select the {Status Data}.
The following table is for support data.
*1: The seat position is forward.
*2: The seat position is rearward.
*3: Displayed when data other than before and behind the seat, such as the breakdown etc, is input.
*4: Displayed when it is initial.
*5: Seat position sensor not supported
*6: Seat belt fastened
*7: Seat belt not fastened
*8: Displayed when data other than belt fastened or not fastened, such as breakdowns is input.
*9: Seat belt buckle switch not supported
*10: Passenger’s seat airbag operating state
*11: Passenger’s seat airbag non-operating state
NOTE:
For details concerning operation procedure, refer to the “SUBARU SELECT MONITOR OPERATION MAN-
UAL”.
3. CLEAR MEMORY MODE
Clear the DTC stored in the airbag control module after repairing airbag system. (After the breakdown is re-
covered, the breakdown code for completed recoveries are read out when the next breakdown occurs if the
memory clear work is not performed.)
1) On the «Main Menu» display screen, select the {Each System Check}.
2) On the «System Selection Menu» display screen, select the {Airbag System}.
3) On the {Airbag System} menu screen, select the {Clear Memory}.
4) When the “Clear Memory?” is shown on the screen, select the [OK].
5) When “Done” is displayed, close the Subaru Select Monitor.
NOTE:
For details concerning operation procedure, refer to the “SUBARU SELECT MONITOR OPERATION MAN-
UAL”.
Item Display contents
Seat position sensor LH Front position
*1
/Rear position
*2
/Other
*3
/Initial Setting
*3
/––
*5
Seat position sensor RH ––
*5
Seat belt buckle switch LH Buckled
*6
/Unbuckled
*7
/Other
*8
/Initial Setting
*4
/––
*9
Seat belt buckle switch RH Buckled
*6
/Unbuckled
*7
/Other
*8
/Initial Setting
*4
/––
*9
Passenger’s airbag control status ON
*10
/OFF
*11
/Initial Setting
*4
asieps_tobira.book 33 ページ ２０１２年２月１０日 金曜日 午後３時２６分