Subaru B9 TRIBECA WX 2007, Manual

Page: 323 / 861

ET-30
Rear Entertainment
ENTERTAINMENT
26.Rear Entertainment
A: REMOVAL
1) Disconnect the ground cable from the battery.
2) Insert a flat tip screw driver in the section, and
remove the room light lens.
3) Remove the bolts, and then remove the monitor
cover.
4) Remove the 4 mounting bolts.
5) Remove the temporary screws and remove the
monitor body.
NOTE:
Always support with one hand to prevent the unit
from falling.
6) Remove the temporary clips from the roof brace.
B: INSTALLATION
1) Attach the temporary clip and temporary screw
to the rear entertainment system body.
NOTE:
When installing a new rear entertainment system, a
clip is supplied on the unit, and step 1) can be omit-
ted.
2) Place the hook of the rear entertainment unit on
the roof brace section.
3) Affix the temporary fixture clips on the roof
brace.
4) Tighten the 4 attachment bolts, and connect the
connector.
5) Connect the room light connector, attach the
cover and affix with the bolts.
6) Attach the room light lens from the outside of the
vehicle and snap into place.
(A) Cutout
(A) Clip
ET-00188
(A)
ET-00189
(A)
ET-00199
ET-00190
asieps_tobira.book 30 ページ ２０１２年２月１０日 金曜日 午後３時２６分