Subaru B9 TRIBECA WX 2007, Manual

Page: 290 / 861

CC(diag)-23
Diagnostic Procedure with Diagnostic Trouble Code (DTC)
CRUISE CONTROL SYSTEM (DIAGNOSTICS)
H: DTC 24
Malfunction of the cruise control related switch.
Refer to DTC 11 for diagnostic procedure.
<Ref. to CC(diag)-15, DTC 11, Diagnostic Procedure with Diagnostic Trouble Code (DTC).>
I: DTC 25
Malfunction of the brake input circuit in ECM.
Refer to the Engine Diagnostic Procedure for diagnostic procedure.
<Ref. to EN(H6DO)(diag)-2, PROCEDURE, Basic Diagnostic Procedure.>
J: DTC 31
Malfunction of the engine speed signal.
Abnormal increase of engine speed is detected.
Gear is set to 1st or Reverse position.
After driving at the 2nd gear position or more, perform the cruise setting again. If the DTC is not detected, it
is normal.
K: DTC 32
Out of vehicle speed range of system operation.
Refer to DTC 22 for diagnostic procedure.
<Ref. to CC(diag)-22, DTC 22, Diagnostic Procedure with Diagnostic Trouble Code (DTC).>
L: DTC 34
Malfunction of throttle opening angle continuous time is detected.
The vehicle has been driven at a speed higher than set speed for a long time (approximately 10 minutes) dur-
ing cruise driving.
DTC is detected when driving for a long period of time at higher speed than appropriate cruise speed by op-
erating accelerator pedal.
Release the cruise setting. If it is not detected again, it is normal.
M: DTC 35
Detected when it is impossible to perform the vehicle speed feedback.
Set vehicle speed cannot be kept for some reasons (steep uphill, unreleased parking brake, etc.) during
cruise driving.
DTC is detected when driving condition is not suitable for cruise control.
Perform cruise set operation again after clearing the possible cause.
N: DTC 41
VDC/TCS has operated.
Vehicle dynamics control (VDC) or TCS is operated during cruise driving or cruise setting.
<Ref. to VDC(diag)-2, PROCEDURE, Basic Diagnostic Procedure.>
O: DTC 43
ABS/VDC malfunction is detected.
VDC malfunction is detected during cruise driving or cruise setting.
<Ref. to VDC(diag)-2, PROCEDURE, Basic Diagnostic Procedure.>
P: DTC 44
Body integrated unit malfunction is detected.
Body integrated unit system malfunction is detected during cruise driving or cruise setting.
<Ref. to LAN(diag)-2, PROCEDURE, Basic Diagnostic Procedure.>
Q: DTC 45
Malfunction of the combination meter is detected.
Combination meter malfunction is detected during cruise driving or cruise setting.
<Ref. to LAN(diag)-2, PROCEDURE, Basic Diagnostic Procedure.>
asieps_tobira.book 23 ページ ２０１２年２月１０日 金曜日 午後３時２６分