Subaru B9 TRIBECA WX 2007, Manual

Page: 394 / 861

EI-41
Instrument Panel Assembly
EXTERIOR/INTERIOR TRIM
13) Make sure that the instrument panel upper is
removed from the steering support beam
14) Disconnect the connectors, and remove the in-
strument panel from vehicle body.
15) Remove the heater vent duct. <Ref. to AC-51,
REMOVAL, Heater Vent Duct.>
16) Remove the air vent grille. <Ref. to AC-49, RE-
MOVAL, Air Vent Grille.>
17) Remove the passenger airbag module. <Ref.
to AB-15, REMOVAL, Passenger’s Airbag Mod-
ule.>
2. STEERING SUPPORT BEAM
1) Remove the instrument panel upper.
2) Remove the bolts, and then remove the knee
guard plate.
3) Remove the steering shaft from the steering
support beam. <Ref. to PS-17, REMOVAL, Tilt
Steering Column.>
4) Remove the bolts and remove the steering sup-
port beam.
3. INSTRUMENT PANEL ASSEMBLY
1) Disconnect the ground cable from battery and
wait for at least 20 seconds before starting work.
2) Remove the console box. <Ref. to EI-38, RE-
MOVAL, Console Box.>
3) Remove the instrument panel lower cover. <Ref.
to EI-36, REMOVAL, Instrument Panel Lower Cov-
er.>
4) Remove the glove box. <Ref. to EI-37, REMOV-
AL, Glove Box.>
5) Remove the center console. <Ref. to EI-39, RE-
MOVAL, Center Console.>
6) Remove the front pillar upper trim. <Ref. to EI-
43, REMOVAL, Side Trim.>
7) Remove the steering shaft from the steering
support beam. <Ref. to PS-17, REMOVAL, Tilt
Steering Column.>
8) Disconnect the connectors, and remove the in-
strument panel from vehicle body.
9) Remove the bolts and remove the steering sup-
port beam.
NOTE:
For positions of the mounting bolt of steering sup-
port beam, refer to the removal procedure of the
steering support beam.
10) Make sure that the each harness connector is
disconnected, and remove the instrument panel as-
sembly from the vehicle body.
NOTE:
Remove the passenger’s side door trim to facilitate
the work.
EI-01331
EI-01332
asieps_tobira.book 41 ページ ２０１２年２月１０日 金曜日 午後３時２６分