Subaru B9 TRIBECA WX 2007, Manual

Page: 657 / 861

LAN(diag)- 8 2
Diagnostic Procedure with Diagnostic Trouble Code (DTC)
LAN SYSTEM (DIAGNOSTICS)
Step Check Yes No
1 CHECK HARNESS.
1) Disconnect the body integrated unit connec-
tor (i84) and keyless entry control module con-
nector (i96).
2) Measure the resistance between har-
nesses.
Connector & terminal
(i84) No. 9 — (i96) No. 3:
Is the resistance less than 10
Ω
?
Go to step 2 . Repair the open
circuit of harness
or replace har-
ness.
2 CHECK HARNESS.
Measure the resistance between harness con-
nector and chassis ground.
Connector & terminal
(i84) No. 9 — Chassis ground:
Is the resistance less than 1
M
Ω ?
Repair the short
circuit of harness
or replace har-
ness. Go to step
3
.
3 CHECK HARNESS.
1) Turn the ignition switch to ON.
2) Measure the voltage between harness con-
nector and chassis ground.
Connector & terminal
(i84) No. 9 (+) — Chassis ground (–):
Is the voltage 6 V or more? Repair the short
circuit of harness
or replace har-
ness. Go to step 4 .
4 OPERATION CHECK
Check the door lock operation when the doors
LOCK/UNLOCK using manual LOCK switch.
Does it operate on switch oper-
ation? Go to step
5
. Replace the body
integrated unit.
<Ref. to SL-51,
REMOVAL, Body
Integrated Unit.>
5 OPERATION CHECK
1) Disconnect the key warning switch connec-
tor (B350).
2) Close all the doors, and then perform the
LOCK/UNLOCK operation on keyless entry
operation.
Does it operate? Check key warning
switch. Replace the key-
less entry control
module. <Ref. to
SL-49, REMOVAL,
Keyless Entry Con-
trol Module.>
asieps_tobira.book 82 ページ ２０１２年２月１０日 金曜日 午後３時２６分