214
9-2
9-1
Trouble shooting
9.1 System messages
The wheel balancer can show messages to the
operator. These may be error related (E-codes)
(e.g.
E
2
-
Figure 9-1
), warnings (H-codes)
(e.g.
H33
-
Figure
9-2
) or Hardware problems (X-Codes). The codes will
be described in the following chapters.
Whenever a code appears:
•
make a note of it;
•
look up the code in the list.
•
perform the steps described.
Important:
If the code is not listed here, call service team.
Errors in operation
-
Error code E
Warnings
-
Error code H
Fatal error code
-
300 or C10
9.1.1 E-Codes
E1
Rim dimensions were entered incorrectly, or
incompletely.
—
When the error code is read out, enter data once
again.
E2
Wheel guard is not closed.
E3
Geodata
gauge arm for distance and rim diameter is
not in home position.
E5
Range of electrical compensation exceeded
(wheel adaptor has unacceptable unbalance).
—
Press
STOP
or
ESC
–key.
—
Check wheel adaptor, repeat compensation run.
E6
The calibration weight was not fi tted for readjustment.
—
Press
STOP
or
ESC
–key.
—
Repeat readjustment.
E7
With this wheel type it is not possible to choose a
balancing mode.
—
If necessary, choose another wheel type.
..
_
..........
