Simons Voss Technologies SmartHandle 3062 Series, Manual

Page: 65 / 136

6. Fasten inside fitting with two screws (X2).
7. Connect the connection cable of the inside fitting with the installation
tool.
8. Check the outer handle to ensure it opens easily. The handle must al-
ways return to its starting position by itself.
9 If the handle catches, repeat the steps of this chapter. Check
whether the fittings are aligned parallel and that the screws are not
pulled too night.
7.5.4.6 Step 4: Check the outer handle to ensure it opens easily
Check the outer handle to ensure it opens easily. The handle must return to
its starting position by itself.
IMPORTANT
If the handle catches, repeat the steps of this chapter. Check whether the
fittings are aligned parallel and that the screws are not pulled too night.
7.5.4.7 Step 5: Installing the inside handle
1. Position the inside cover (11) on the inside fitting without fastening it.
Notice that the cover can only be placed onto the fitting in one direction.
9
The cover is positioned flush on the inside fitting but without
fastening it.
2. Push inlay (11) onto the inside handle retainer. Ensure that the black side
of the inlay is turned towards the door.
3. Insert inner handle horizontally into the inside fitting in the direction you
require (DIN left or DIN right).
9
The inside handle is placed in the inside fitting without being
fastened.
4. Tighten the headless screw to fasten inside handle.
9
The inner door handle is now firmly linked to the SmartHandle.
5. Check the handle mechanism to ensure it opens easily.
9
Repeat the procedure described in this section if the handle should
catch or jam!
IMPORTANT
For easier installation, in most cases the cover can be pushed over the inlay
later in chapter "
Step 6: Fastening the covers [
}
66] ".
SmartHandle (Manual)
7. Installation (manual)
65 / 136