14. The outer fitting (4) is mounted from the outer side of the door. Push
the spindle slot in the outer fitting (4) onto the spindle while pushing the
snap-in mechanism (7) on the outer fitting (4) into the snap-in (7) on
the inside fitting (8).
15. Push on outer fitting (4) until it is about 1 cm from the door.
16. Push the inside fitting 3-pole cable through the elongated hole in the
outer fitting. Do not pull on the cable while doing so (Diagram 8).
17. Connect the 3-pole cable from the inside fitting to the 3-pole cable
from the outer fitting. This cable can only be inserted in one direction.
Do not pull on the cables while doing so; just carefully secure the plug-in
connection into position.
18. Optional: Connect the 2-pole cable from the LockNode to the 2-pole
cable from the inside fitting.
19. The 2-pole cable from the outer fitting can hang freely, but must not get
caught when the outer cover (1) is fitted. Do not pull on the cable.
20.Press outer and inside fittings together, so that they are both flush
against the door.
21. Push mounting screw (9) through the snap-in mechanism (7) from the
inner side of the door and tighten by hand, using about 5-7 Nm.
22. Check that the outer handle (3) can turn easily; if it does not, there may
be a problem with the lock or the handle may have been fitted incor-
rectly. In case of doubt, disassemble components and start again from
Step 7. Depending on the handle model, it may not be possible to fit it
once the handle is installed.
23. Push inside handle (10) onto the inner fitting (8) fastening flange until it
will go no further.
24.Tighten the hexagon screw (11) on the inside handle (10) by hand, so
that it is flush with the handle.
25. Push the cover (12) over the inside handle (10).
26.Carefully push the inlay (13) through the opening in the inside cover (12).
27. Push the cover (12) onto the inside fitting (8), so that it is flush with the
door. The cover is not symmetrical; look carefully at the marking to en-
sure correct positioning (Diagram 10).
28.Click the inlay (13) carefully into the cover (12).
29.Push the cover (1) over the outside handle (3).
30.Carefully push the inlay (1) through the opening in the outside cover (2).
31. Push the cover (2) onto the outer fitting (4), so that it is flush with the
door. The cover is not symmetrical; look carefully at the marking to en-
sure correct positioning (Diagram 10).
32. Push the inlay (1) over the handle (3) and click it into place in the cover.
SmartHandle
(Manual)
7. Installation (manual)
32 / 136
