34.Push the cover (2) over the outside handle (3).
35.Carefully push the inlay (1) through the opening in the outside cover (2).
36.Push the cover (2) onto the outer fitting (4), so that it is flush with the
door. The cover is not symmetrical; look carefully at the marking to en-
sure correct positioning (Diagram 7).
37. Click the inlay (1) carefully into the cover (2).
7.3.6 Diagrams for conventional fastening system
Figure 2:
Handle fastener piece
Figure 3:
Handle fastener piece open
Figure 4:
Handle fastener piece closed
Figure 5:
Fastener piece - correct position for
the handle fastener piece when
closed
Figure 6:
Figure 7:
Tab. 2:
Diagrams showing installation
7.3.7 Storage mode for conventional fastening system
1. Disconnect the 3-pole cable from the inside fitting with the 3-pole cable
from the outer fitting. If necessary, also disconnect the LockNode cable
from the inside fitting.
2. Hold the inside and outer fittings firmly while pulling them away from
one another horizontally.
Fitted to the door:
IMPORTANT
General instructions: Depending on the handle model, it may not be pos-
sible to remove the inlay immediately. In such a case, push the inlay
through the opening in the cover and remove the cover. The inlay remains
on the handle and cannot be removed until the handle is dismounted.
Follow the same steps as for installation but in reverse order.
SmartHandle
(Manual)
7. Installation (manual)
50 / 136
