13 Battery replacement
13.1 General instructions
Only trained specialists may carry out installation and programming or
replace the batteries.
Do not touch electronics/components; do not allow them to come into
contact with oil, paint, moisture, alkali or acids.
The electronics must not be subject to mechanical stress or damaged in
any way.
The batteries used may pose a fire or burn hazard if handled incorrectly.
Do not recharge, open, heat or burn these batteries. Do not short-circuit!
Only use batteries which have been approved by SimonsVoss.
Do not touch the contacts on the new batteries with your hands when
replacing the old ones. Use clean gloves free of fat or grease to handle
the battery.
Damage may be caused to SmartHandle 3062 if you reverse the
battery polarity.
Dispose of old and used batteries in the proper manner and store them
out of children's reach.
Always replace both batteries when changing batteries!
All SmartHandle 3062 must be operated with two batteries in the inside
fitting! Hybrid variants delivered up to January 2016 are operated with
four batteries (two in the inside fitting, two in the outer fitting). Hybrid
variants (black battery holder with cover) delivered after this are only
operated with two batteries in the inside fitting. The battery is changed
as with non-hybrid variants.
13.2 Procedure with SmartHandle WP-SC
The batteries are installed in the internal area in the case of SmartHandle
active, SmartHandle WP or SmartHandle SC WP.
In January 2016, the battery holder was converted to a black plastic box
with cover. The procedure is slightly different.
IMPORTANT
Do not touch the contacts on the new batteries with your hands when re-
placing the old ones. Use cotton gloves free of fat or grease.
SmartHandle
(Manual)
13. Battery replacement
113 / 136
