32. Fasten the cylinder with the fastening screw by hand (about 5-7 Nm)
(note that cylinder and fastening screw are not part of the supply).
33. Carefully push the 3-pole cable into the outer fitting.
34.Push inlay (14) onto the inside handle (11). Depending on the handle
model, it may not be possible to fit it once the handle is installed. Push
inside handle (11) onto the inner fitting (8) fastening flange until it will go
no further.
35.Fasten the hexagon screw (12) on the inside handle (11) firmly by hand.
36.Push the cover (13) over the inside handle (11).
37. Carefully push the inlay (14) through the opening in the inside cover (13).
38.Push the cover (13) onto the inside fitting (8), so that it is flush with the
door. The cover is not symmetrical; look carefully at the marking to en-
sure correct positioning (Diagram 7).
39.Click the inlay (14) carefully into the cover (13).
40
.
Push the cover (1) over the outside handle (3).
41. Carefully push the inlay (1) through the opening in the outside cover (2).
42.Push the cover (2) onto the outer fitting (4), so that it is flush with the
door. The cover is not symmetrical; look carefully at the marking to en-
sure correct positioning (Diagram 7).
43.Click the inlay (1) carefully into the cover (2).
7.4.5 Conventional fastening system MO WP
Installation:
1. Optional: handles, escutcheons, fittings and other door furniture fitted
to the door are to be removed.
2. SmartHandle is partly assembled when supplied; see "Disassembly".
SmartHandle
(Manual)
7. Installation (manual)
55 / 136
