23. Insert the lower battery (13) with the positive terminals facing away
from the door into the brackets; in doing so, insert the batteries under
the black retaining collar first. Use clean gloves free of fat or grease to
handle batteries.
24.Carefully lock the electronics cover lid back into place.
25. Connect the 2-pole cable from the outer fitting (4) to the 2-pole cable
from the inside fitting (11). This cable can only be inserted in one direc-
tion. Do not pull on the cables while doing so; just carefully secure the
plug-in connection into position. Optional: Connect the two-pole cable
on the additional electronic module on the outer side with the corres-
ponding cable from the inside fitting.
26.The 2-pole cable from the outer fitting may hang freely; when mounting
the outside cover (2) onto the fitting, ensure that the cables do not get
caught or broken. Do not pull on the cables. The second cable is option-
ally used to connect the LockNode circuit board.
27. Check that the outer handle (3) can turn easily; if it does not, there may
be a problem with the mortise lock (8) or the handle may have been fit-
ted incorrectly. In case of doubt, disassemble components and start
again from Step 4.
28.Push inlay (17) onto the inside handle (14). Depending on the handle
model, it may not be possible to fit it once the handle is installed.
29.Push inside handle (14) onto the inside fitting (11) fastening flange until
it will go no further.
30.Tighten the inside handle (15) hexagon screw firmly by hand, using
about 5-7 Nm.
31. Push the cover (16) over the inside handle (14).
32. Carefully push the inlay (17) through the opening in the inside cover (16).
33. Push the cover (16) onto the inside fitting (11), so that it is flush with the
door. The cover is not symmetrical; look carefully at the marking to en-
sure correct positioning.
34.Click the inlay (17) carefully into the cover (16).
35.Push the cover (2) over the outside handle (3). The cover acts as an an-
tenna for the LockNode.
36.Carefully push the inlay (1) through the opening in the outside cover (2).
37. Push the cover (2) onto the outer fitting (4), so that it is flush with the
door. The cover is not symmetrical; look carefully at the marking to en-
sure correct positioning.
38.Click the inlay (1) carefully into the cover (2).
SmartHandle
(Manual)
7. Installation (manual)
88 / 136
