![background image](http://html1.mh-extra.com/html/simons-voss-technologies/smarthandle-3062-series/smarthandle-3062-series_manual_1275869062.webp)
SKG components
A
Adapter plate for inside fitting
B
Installation key for outer fitting
C
Adapter plate for outer fitting
D
Spacer plate for outer fitting
7.5.4.2 Step 0: Preparing drill holes
IMPORTANT
The mortise lock must be removed from the lock before drilling to avoid
damaging it. The door lock can be re-fitted to the door once drilling is com-
plete.
IMPORTANT
The mortise lock must feature a drill hole as specified in DIN 18251, other-
wise SmartHandle 3062 cannot be installed. It is assumed that the mortise
lock has been fitted according to instructions.
1. Align drilling template precisely.
9
The cut for the spindle must be positioned exactly over the retainer
opening in the door lock.
9
The template must be positioned completely parallel to the door
edge. The dimension lines act as a reference.
9
The centre hole must fit precisely over the hole in the lock.
2. Use a suitable pen or pencil to mark the required drill holes.
3. Place drilling template back on again to check the marks are correct.
4. Dismount door lock from door.
5. Drill top hole with a suitable 8-mm drill bit.
6. Drill middle hole with a suitable 8-mm drill bit.
7. Drill lower hole with a suitable 13-mm drill bit.
It is recommended to pre-
drill the hole with a 8 mm bit first.
8. Re-fit door lock to door.
7.5.4.3 Step 1: Preparing to install the outer fitting
1. Place outer cover (2) loosely onto the outer fitting (4). Notice that the
outer cover can only be placed onto the fitting in one direction.
9
The outer cover is positioned flush on the outer fitting but without
fastening it.
2. Push inlay (1) onto the outer handle (3) from the short side. Ensure that
the black side of the inlay is turned towards the door.
SmartHandle
(Manual)
7. Installation (manual)
62 / 136